Date Reported: January 5, 2011
Status: Confirmed (10.4.0)
Problem: MicroSurvey Menus do not load after updating inCAD 2010 to 2011
Solution: Deleting support paths and re-running program will cause them to be rebuilt. Please see this article for the solution:
Date Reported: May 18, 2010
Status: Confirmed (10.1.1)
Problem: Insert Sheet and Title Block "Move" option interferes with attribute prompts
Solution: The routine works well when the option is set to display a dialog box for attributes rather than prompting in the command line. Type attdia in the command line and set it to "1." The routine should work fine now. Close and reopen the program to make the setting permanent.
Date Reported: December 18, 2009
Status: Confirmed (10.1.0)
Problem: MicroSurvey Menus are not loaded after install, until you open a drawing.
Solution: inCAD 2011 will always launch Project Manager and load the MicroSurvey menus after a drawing is selected.
Date Reported: November 2, 2009
Status: Confirmed (10.1.0)
Problem: When running inCAD under Windows Vista or Windows 7, the "What's This?" Help feature does not work.
Solution: If you wish to use the MicroSurvey inCAD "What's This?" Help feature, you will need to download and install an update from Microsoft, because Vista and 7 do not ship with the WinHelp32 viewer. Please refer to the following Microsoft Knowledge Base article for more information. Please note, the main MicroSurvey inCAD Help file will work without this update.
Brian Sloman
Comments